Step 1: Hold the needle tube of the tattoo machine with your left hand, press the bottom of the "main base" with your index finger, and press the position of the "needle tube fixing button" with your thumb.
Step 2: Connect the AC power supply and connect the cable to the tattoo machine jack.
Step 3: Use the thumb and index finger of your right hand to pinch the "fixed adjustment button" and adjust it to the "relaxed" state.
Step 4: Pinch the "pressure regulator" with the thumb and index finger of your right hand, adjust the "pressure regulator" and step on the "footswitch" with your right foot to start the tattoo machine.
Step 5: When adjusting the "pressure adjustment button" with the thumb and index finger of the right hand, be careful not to leave or relax the "pressure adjustment button" with the right hand until the tattoo machine produces the best speed and sound. At the same time, touch the front end of the magnetic strip with the thumb of your left hand, below the needle bar fixing button. According to whether the left thumb touch is the maximum vibration (until you feel numb or itchy), the tattoo machine is in the best working state.
Step 6: When debugging the tattoo machine, we need to pay attention to the stroke of the tattoo machine. (Stroke means the distance between the magnetic strip and the magnetic coil of the tattoo machine) The stroke must be at least 2.5MM. This is because the needle has a sufficient telescopic distance to ensure that the needle can penetrate into the bottom layer of the epidermis when it is extended, and it can be retracted into the needle tube and stained with pigment when it is retracted.
Step 7: When the tattoo machine is in the best state, leave the "footswitch" with your right foot-cut off the power supply, and the tattoo machine is in a stopped state. Use your right thumb and index finger to adjust the "adjustment fixing button" to the tightest state and lock it. "Pressure adjustment button".
Note: After completing the above seven steps, restart the tattoo machine and try it out! Best working condition! The tattoo machine debugging is completed. When the tattoo machine uses a professional voltage stabilizer, the voltage used for the secant is 9-12V, and the voltage used for painting or fogging is 12-14V.
