1. After the no-load debugging of the tattoo machine, it feels sound and strength are ideal, first install the handle and tighten the screws slightly, then install the tattoo needle.
2. Check whether the tattoo needle is intact, insert the tattoo needle from the upper end of the handle, and then put the rubber ring into the position of the four iron cylinder.
3. Install the needle tube and adjust the position of the handle. Hold the tattoo machine with your left hand, press down on the cylinder of the square iron with your thumb, and force the square iron to touch the core surface of the coil. Adjust the handle with your right hand to expose the needle of the tattoo machine to about 1 mm. (That's about half the thickness of a dollar coin).
4. Use a "rubber band" (soft rubber ring for girls to tie their hair) around the bottom of the needle bar about 8 mm down to tie the needle bar and the body to the waist. , Too tight will affect the speed. So you can start working!
