First, the width and width of the front and back single pieces are adjusted. The length of the shrapnel bought is fixed. Then we can adjust the width and width of the shrapnel to achieve the desired effect, but we must pay attention to the matching of the front and back shrapnels, otherwise there will be bursts. All right!
Second, the machine rack setting is also very important. Some rack settings are very good, but because the shrapnel does not meet the good requirements, unsatisfactory results will occur. The rack is also fixed when bought back. We can adjust the seat of the shrapnel at the rear of the rack to be smaller to increase the distance to the armature. Of course, we can also adjust the armature to increase the distance, but we must pay attention to the relationship between the armature and the rear coil, and then we can adjust the height of the rear seat of the rack. The relationship comes to the strength of the Zengda machine. (There is no picture here, so the explanation is not very clear, I will explain it later)
The third is the material of the machine, which is also a concern for many people. In fact, the material of the machine is not too particular about it. The main thing is that the strength is sufficient. It is not said that different materials have any effect on the speed of the machine. Impact ~! I have tried this myself.
The fourth is the damping ring. As long as there is a good cooperation between the shrapnel and the frame, the change of the damping ring will not have any impact. Of course, the strength of the machine will be greater if the damping ring is removed.
