The tattoo process is divided into two main steps: "cutting line" and "fogging". However, a very important procedure is often overlooked, namely "planning". "Planning" is divided into two parts, one refers to the planning of the model, and the other refers to the understanding of the model. The long-term development of the pattern needs to be considered, and the improvement in the future is considered, because the tattoo is a kind of identification of its own body and it has continuity.
1. Cutting a good tattoo must have a good composition and correct cutting. Many people and even professional tattoo artists will have cuts that are too shallow, too thin, or maybe the lines are muddy. Incorrect results using tools or tattoos.
Most tattoo masters use imported tattoo machines, but before it was necessary to tie the needles and burn the needles (tied several needles together and then bonded them with solder), in order to reduce the work pressure of the tattoo artist, Tattoo needles are now available (single needle to three needles), but the general layman, perhaps the tattoo crazy people who are at home are almost all using the tattoo machine (we never recommend using tattoo machine to tattoo) . Because the torque and rotation speed of the motor of the eyebrow tattoo machine are too short, if you want to tattoo thick, black and even lines, you must use a professional tattoo machine, but you must also master the appropriate methods and methods.
When cutting the line, pay attention to the angle between the tattoo machine and the skin. The larger angle should not exceed 30°. If it exceeds 30°, it will easily lead to a scene where the lines are muddy. Perhaps it is not colored. We know that when straight, the cut line is more When it is dark black, the depth of the lower needle should not be too deep, preferably 1-1.5mm.
2. Fog and fog can be said that there is no specific method. Some people tear from the inside out, and use the heavier local to make heavy fog, and end the lighter local as light fog. We temporarily call it the "Northwest Rain" pattern ( Because its shortcoming is that the fog that comes out will form a fog like a radial line).
Some people use the spiral method from the inside to the outside, and the force is heavier at first. When it becomes a heavy fog, another method is to continue to go back and forth like the printer head of the printer and gradually expand outward. The initial local output is heavier and gradually Putting light on the ground can also form the same fog as the gradient.
