Tip one: After the pattern size of the transfer paper is set, the copied transfer pattern is cut into a circle according to the size of the pattern, and then cut into a radial shape at a certain distance around the pattern, and then Transfer, the benefits of doing this: the transfer pattern can be comfortably attached to the transferred part, without wrinkling. Note: Do not cut the pattern lines short when cutting paper
Tip two: Use baby moisturizing oil instead of petrolatum when cutting the lines. After setting the pattern lines, use petrol moisturizing oil instead of petrolatum. Apply a thin layer and cut the first-grade stick. There are many benefits, you will know if you try
Tip three: women's breasts and waists should be fixed in the {normal posture} body posture of the waist, especially some symmetrical figures, because the stretching of the waist standing and sitting patterns change greatly, you must pay attention to Then I made a butterfly pattern for the chest of a female guest at the time. I did n’t consider it if the pattern changed when she took off her underwear. Later, this female guest asked me to explain how to change the overall shape of the butterfly when taking a bath with her partner. ? ? I said, I have n’t really considered the change between wearing underwear and not wearing underwear, she ’s embarrassed,
Tip four: the tattoo gun works for a long time. The top wire and the shrapnel contacts are easily oxidized and contaminated, which directly affects the normal operation of the tattoo gun. If you have no time to disassemble and clean, then you will prepare a small piece of sandpaper with the finest mesh in advance and then fold it in light. In this case, the tattoo gun will work normally after gently rubbing a few times between the shrapnel and the top wire contact and then blowing clean sand.
Tip 5: How to prevent the needle nozzle from spraying ink when cutting the fog 1. Fix the rubber ring. 2. When the round needle is installed, turn the tin connector outward, and then gently bend it inward a small arc to make it close to the needle mouth. 3. When the needle is installed, the direction of the round needle and tin interface is opposite, and then a small arc is also bent to close the needle mouth. 4. Choose the proper needle mouth, not too big than the installed needle.
