1. After the tattoo machine has been debugged without load, the sound and strength are ideal. First install the handle and tighten the screws slightly, then install the tattoo needle.
2. Check if the tattoo needle is intact, insert a T-shaped rubber ring (supplied) at the ring of the needle bar, insert the tattoo needle from the upper end of the handle, and then insert the rubber ring into the square iron cylindrical position.
3. Install the needle tube and adjust the position of the handle. Hold the tattoo machine with your left hand, press down on the square of the square iron with your thumb and press down firmly so that the square iron touches the core surface of the coil, and adjust the handle with your right hand to expose the tattoo needle to the length of the needle nozzle about 1-1.5mm (that is, one yuan coin) About half thick).
4. Use "rubber band" (soft rubber ring for girls to tie their hair) to bundle the needle bar and the body around the bottom of the ring of the needle bar about 8 mm, tight and moderate, to prevent the tattoo needle from coming out during work , Too tight will affect the speed. So you can start working!
