Tip 1: Use the transfer paper to determine the size of the pattern, cut the copied transfer pattern into a circle according to the size of the pattern, then cut the radial pattern at a certain distance around the pattern, and then Transfer, the benefits of doing this: allows the transfer pattern to be comfortably attached to the transferred part without wrinkling.
Note: Do not cut the pattern lines short when cutting paper
Tip 2: Use baby moisturizing oil instead of petrolatum when cutting the lines. After setting the pattern lines, use petrol moisturizing oil instead of petrolatum, apply a thin layer, and cut the first-grade stick. There are many benefits, you will know if you try
Tip 3: How to prevent the needle nozzle from jetting ink when cutting the fog 1. Fix the rubber ring. 2. When the round needle is installed, turn the tin connector outward, and then gently bend it inward by a small arc to make it stick to the needle mouth. 3. When the needle is installed, the direction of the needle is opposite to that of the round pin tin interface, and then a small arc is also bent to close the needle mouth. 4. Choose the proper needle mouth, not too much than the installed needle. Try to see if it is not inkjet.
Tip four: a pen for drawing pictures on the skin. There is such a professional pen in tattoo equipment, but I am not used to it. Because the small lines are not good for performance, I use many different performances in actual operation. Finally choose the small head neutral ballpoint pen on the market {no sanitation problems have been studied, and no adverse reactions and allergies have been found}
Operation: After the skin is strictly disinfected, wait for the alcohol to dry, then prepare the cardboard, draw a picture on the skin, and when the pen does not contain water, draw on the cardboard and you can continue to use it.
