In this age, there are many diseases and viruses, many of which are incurable, and some are fatal. Therefore, proper disinfection is a very serious matter. You should think in advance that you should not use unsterilized equipment under any circumstances. All needles, needle tips, needle shafts and tattoo pigments should be sterilized.
Disinfect the equipment before use. First, put the new needle and needle tip into an ultrasonic cleaner. Some chemical cleaning substances can be used in the ultrasonic cleaner. This can remove all the welding agent on the needle and has a miraculous effect on removing the pigment in the needle tip. The needles can be scrubbed by hand for 5 minutes. When they are placed in the ultrasonic cleaner, the colorant will boil and be removed from above. You may not have an ultrasonic cleaner at the beginning, but if you plan to do a lot of tattoos, you will soon realize that you really need such a machine. You can buy a cleaner with a detachable basket. They will leave a deep impression on the healthy organization responsible for checking the hygiene of your store and will definitely make you feel worthwhile.
When putting the device into the cleaner, be careful not to touch the needle tip, otherwise it will be damaged. Put the needle in gently, taking care that all the needle tips are facing one direction. During the cleaning process, sometimes the ultrasonic cleaner will dim the needles and hook them. To improve this, place a pencil under the two legs of the ultrasound machine, tilt one end up higher than the other, and make the needle toward the higher end, and you won't have any trouble.
When the equipment is placed in the ultrasonic cleaner for half an hour and then taken out, it is easy to brush off the residual color or other things, you can use a toothbrush to brush. Use a short-haired brush to clean the outside of the metal tube, and use a long-haired brush to clean the inside of the needle tip and the needle opening. The short-haired brush is also effective in cleaning the needle.
To clean a needle, brush the inside and outside thoroughly, scrubbing vigorously while washing it under the tap with water.
The ultrasonic wave sink should be placed next to the tattoo machine. It will be your best friend at work. It will take less time and more thorough than you can clean the color of the needle mouth by hand. Tattoo color is very stubborn and difficult to remove. Sometimes even after cleaning in an ultrasonic container, you will find traces of color on the needle or needle tip.
When cleaning the needle connected to the end of the needle bar, sprinkle some soap powder on the dirty place you choose, hold the toothbrush in your right hand and the needle bar in your left hand, and the other part of the needle tip is against your index finger. Usually the direction of the needle tip should be scrubbed vigorously in only one direction. Pull the end of the needle bar and the needle will pass through the back of the brush without damaging the needle tip. Start moving over the brush, then slowly go down through the brush.
