When a tattoo machine is in your hand, only the following links can be adjusted: front shrapnel, rear shrapnel, rear spacing, contact screw, shock absorber ring, coil position, rubber band, armature. The coil, iron core, frame, and capacitor are basically immobile. Where is the best tattoo
All adjustments revolve around two factors-frequency and power, the following will be one by one.
Front shrapnel: the length, width, width, thickness, thickness, softness and bending angle will affect the frequency and strength of the machine. Long, narrow, thin, soft, and low bending angles will slow down the machine frequency and increase the strength. Conversely, the frequency becomes faster and the power becomes smaller.
Shock absorber ring: thick and soft, thin and soft makes the frequency slower and the power becomes larger. vice versa. In fact, the shock absorber ring is the extension of the front shrapnel. A good front shrapnel may not even need a shock absorber ring, so that the power of the front shrapnel is maximized and the power is maximum.
Contact screw: The closer the contact point is to the tip of the front shrapnel, the slower the frequency and the greater the force, and vice versa. The tighter the contact screw is, the smaller the force and the faster the frequency. It is recommended that the contact screw be as close to the front as possible, lightly touch the shrapnel, and then turn it down one or two times at most, so that the shrapnel exerts its maximum power.
Rear shrapnel: width, softness and bending angle will affect the machine's frequency, strength and length of needle. Narrow, thin, and soft will make the machine slower and more powerful. Conversely, the frequency becomes faster and the power becomes smaller. The greater the bending angle, the longer the needle, the greater the power of the machine, and the slower the frequency, and vice versa.
Rear spacing: refers to the distance between the rear seat of the machine and the armature. In fact, this distance is to change the length of the rear shrapnel. It can be achieved in several ways. Adjust the length of the armature, the size of the rear shrapnel, the forward movement of the rear shrapnel, Both can change the rear spacing. The greater the rear gap, the greater the power and the slower the frequency, and vice versa.
The position of the coil: the more the front coil (the one close to the needle), the greater the force, and the greater the distance between the front and rear coils, the greater the force. It is recommended that the front coil be as close to the front as possible, and the rear coil should not move.
Armature: The material, length and weight of the armature, the longer the armature, the heavier the power, the slower the frequency. For the time being, I only know that the better the magnetism is, the better the armature is.
Rubber band: Use as little as possible, as long as you can control the beating of the needle, the correct way of loading the needle can reduce the beating of the needle, so only one or two rubber bands are needed.
Under normal circumstances, the thorn color and totem require large machine power and slow frequency. The black and white traditional and sketching requires small machine power and fast frequency.
Everyone can adjust their own machines according to the above rules.
