The tattoo process is divided into two main steps: "cutting line" and "fogging". However, a very important procedure is often overlooked, namely "planning". "Planning" is divided into two parts, one refers to the planning of the model, and the other refers to the understanding of the model. Planning means that we must consider patterns when decorating customers.
First, secant
A good tattoo must first have a good composition and correct cutting line. Many people and even professional tattoo artists will have a cut line that is too shallow, too thin, or maybe the line is muddy. This is the use of utensils or tattoos. Incorrect results.
Most tattoo masters use imported tattoo machines, but before it was necessary to tie the needles and burn the needles (tied several needles together and then bonded them with solder), in order to reduce the work pressure of the tattoo artist, Tattoo needles are now available (single needle to three needles), but the general layman, perhaps the tattoo crazy people who are at home are almost all using the tattoo machine (we never recommend using tattoo machine to tattoo) . Shanghai Flower Arm Tattoo is too short because of the torque and speed of the motor of the eyebrow tattoo machine. If you want to print thick, dark and even lines, you must use a professional tattoo machine, but you must also master the appropriate methods and methods.
When cutting the line, you should pay attention to the angle between the tattoo machine and the skin. The large angle should not exceed 30°. If it exceeds 30°, it will easily lead to a scene where the lines are muddy. Maybe it is not colored. We know that when straight, the cut line is thick. When it is black or thorns, the depth of the lower needle should not be too deep, preferably 1-1.5mm.
Second, hit the fog
It can be said that there is no specific method for fogging. Some people tear from the inside out, and use the heavier local area to make heavy fog, and end the lighter local area as light fog. We temporarily call it the "Northwest Rain" pattern (because of its The disadvantage is that the fog that comes out will form a fog like a radial line).
Some people use the spiral method from the inside to the outside, which makes the force heavier at first. When it becomes a heavy fog, another method is to continue to go back and forth like the printer head of the printer and gradually expand outward. The initial local output is heavier and gradually You can also form the same fog as a gradient by letting go of light.
