A good tattoo must have a good composition

 Jun 12, 2020

 Leave a message

 

The process of tattooing is divided into two stages: "cutting the thread" and "hitting the fog", but often overlooks a very important step-"planning". "Plan" is divided into two parts, one is the design of the pattern, and the other is the understanding of the pattern. Design means that while we are marking the customer, it is also necessary to consider the long-term development of the pattern and the future improvements. Because tattoo is a kind of identification of one's own body, it has continuity.

    A good tattoo work must have a good composition first, and then the correct cutting line. Many people or even professional tattoo artists will have cutting lines that are too shallow, too thin, or the lines are muddy. This is all used. Incorrect results for utensils or tattoo methods. If you want to make thick, dark and even lines, you need to use a professional tattoo machine, but you must also master the appropriate methods and methods.

    Fogging is the coloring we refer to. Fogging can be said that there is no specific way. Someone tears from the inside out, and makes the heavy fog with the heavier place at the beginning, and the light fog at the end. Some people use the spiral method to start from the inside to the outside to make the force heavier. When it becomes a heavy fog, another way is like the nozzle of the printer. It continues to move back and forth and gradually develops outward. The output at the beginning is heavier and gradually When you lighten your strength, you can also form fog like a gradient.

    Adjust the length of the needle out of the tattoo machine carefully, because the line thickness determined by the length of the needle out. In general, too long adjustments should be avoided because: 1. The needle is too shallow, the pigment will dissolve in the blood and spread, resulting in a situation commonly known as "muddy". The lower needle is too deep, which can easily damage the dermis and cause scars. Therefore, we recommend that the depth of the lower needle of the tattoo machine should be within 1mm.

    The angle of the cutting line should not exceed 20°C, because if the angle is too large, the needle is prone to the line being turbid, and the angle of the lower needle is perpendicular to the skin and it is easy to color.

    When using the transfer method to cut the thread, you should pay attention to the order of cutting, and follow the order of "from bottom to top, from right to left", because it is not easy to cause the situation of grinding and transferring the pattern.

    As long as you follow the correct method and use professional tattoo equipment, I believe that in the near future you will also make good works that are satisfactory to both guests and yourself.


Send Inquiry
Send Inquiry